Angle pins, or slant pins, drive the slide as the mould opens. Machined from SKD61, hardened and ground, at our Dongguan factory (DongGuan CT Mould).
| Diameter | 8 – 40 mm |
| Angle | up to 25° |
| Material | SKD61 / SUJ2 |
| Hardness | SKD61 through-hardened ≈HRC 50–55; SUJ2 ≈HRC 58–62 |
| Straightness | 0.01 mm / 100 mm |
| Surface | ground Ra 0.4 |
Values are typical. Send your drawing and we confirm against the actual requirement — we do not quote from a catalogue.
Inspection report requirements are confirmed per order.
±0.05° on the angled section.
Yes — shoulder or threaded mounting to drawing.
SKD61 through-hardened ≈HRC 50–55 is standard for angle pins.
STEP / IGES / DWG / PDF all accepted. We reply within one business day. One piece is acceptable for standard sizes.
Request a quoteBuying several components for the same mould? Send one drawing pack and we quote them together, ship them together.